Roofing in Newark, NJ

What roof-inspection Includes

A real roof inspection walks the whole assembly, not just the field.

• Deck and substrate check: sheathing, plywood or osb, truss and rafter condition from attic or hatch.
• Membrane and surface: built-up roof layers, modified bitumen, tpo, epdm, or pvc membrane seams.
• Water-shedding details: drip edge, eave, rake, valley, ridge, ridge cap, and vent boot.
• Penetrations: chimney flashing, step flashing, counter-flashing, pipe flashing, skylight, dormer.
• Drainage: gutter, downspout, scupper, and any sign of ponding water.
• Ventilation: ridge vent, soffit vent, attic fan, insulation contact.

Then we write a roof estimate with a clear scope of work. Debris goes in a dumpster. Tarp goes on anything open.

Quality & Materials Standards

Material choice follows the roof, not a sales sheet. Flat Newark rowhouses usually want modified bitumen or a membrane; steep brownstone pitches take architectural shingle, three-tab shingle, or slate where the structure allows. Wood shake and cedar shake appear on older homes and need honest condition talk.

Every assembly gets the right layers: underlayment, synthetic underlayment, roofing felt or tar paper, ice-and-water shield at the eave, and primer where a coating is specified. Fasteners matter — nail, screw, and anchor selection depends on decking and substrate. Building code sets the floor, not the ceiling.

When storm damage hits, we document it for your insurance claim: photos, measurements, and a written scope. Your adjuster reviews it. We speak the language — deductible, depreciation, replacement cost, proof of loss, supplement, policy coverage, claim documentation. No inflated promises.

Local Service Areas

Central Ward

Dense early-1900s brick rowhouses where flat roofs and shared parapet walls fail first.

• Built-up roof and tar surfaces blistering after summer heat.
• Parapet and coping seams opening, letting rain into the roof deck.
• Ponding water near scupper drains that were never re-pitched.
• Old flashing at party walls pulling away from the brick.

North Ward

Branch Brook Park’s edge is lined with Victorian and Edwardian multi-family brownstones.

• Slate and clay tile slipping on steep mansard and gambrel pitches.
• Chimney flashing and counter-flashing cracking at the masonry joint.
• Rotted fascia and soffit behind clogged gutter runs.
• Ice dam formation along north-facing eave lines.

East Ward

Mixed rowhouses and post-war apartment buildings with aging flat and low-slope roofs.

• Modified bitumen seams splitting at the lap.
• Membrane punctures around vent boot and pipe flashing.
• Sagging roofline from saturated sheathing and rafters.
• Downspout blockages backing water under the drip edge.

South Ward

Older brick rowhouses and brownstones where original wood and slate are near end of life.

• Wood shake and cedar shake curling and losing granulated surface.
• Felt and tar paper underlayment disintegrating beneath the field.
• Valley and step flashing rusted through at additions.
• Loose ridge cap and ridge vent after nor’easter winds.

West Ward

Post-war residential apartment buildings and rowhouses with large flat rooftop areas.

• Tpo and epdm membrane shrinkage at seams and edges.
• Blistering from trapped moisture in the insulation below.
• Corroded metal panel and standing-seam panel fasteners.
• Clogged drains causing ponding water and structural load.